About the data

What the numbers mean

A water level is a height above a chosen zero, called a datum. Learn what MLLW, MHHW, MSL, and NAVD88 mean and how to switch between them.

A water level in Tide Alerts is the height of the water surface above a zero line. That zero line is called a datum. A water level is not the depth of the water.

Think of a mark painted on a piling. Every reading says how far the water is above or below that mark. If you move the mark, the same water gets a different number.

Common datums

DatumStands forWhat its zero is
MLLWMean Lower Low WaterThe average of the lower of each day's two low tides. The usual zero on US tide charts
MLWMean Low WaterThe average of all low tides
MSLMean Sea LevelThe average water level
MHWMean High WaterThe average of all high tides
MHHWMean Higher High WaterThe average of the higher of each day's two high tides
NAVD88North American Vertical Datum of 1988A land-survey zero used for maps, roads, and flood maps. Not a tide datum

NOAA averages these tidal datums over a 19-year period at each gauge. They are statistics for that spot, not a survey of the water bottom. See NOAA's datum definitions.

Reading values above MLLW

  • 0.0 ft MLLW is a typical lowest low tide at that gauge.
  • +3.0 ft MLLW means the water is about 3 feet above that typical lowest low.
  • A negative value, such as −0.5 ft MLLW, means the water is below that average. This is normal on some days of the month.

Switch the datum

A station's Overview lists the datums that station has, with their heights. Use the datum menu on a station page to show its readings and predictions against another datum. Only the zero changes; the water stays where it is.

Stations offer different datums. If a station has none listed, Tide Alerts shows MLLW and NAVD88.

Depth under a boat

A tide height alone does not tell you the depth. For a rough idea:

  1. Find the charted depth on a nautical chart. In the US it is usually measured from MLLW.
  2. Add the tide height in MLLW from Tide Alerts.

For example, a charted depth of 4 ft and a tide of +2.5 ft MLLW gives about 6.5 ft of water. Channels silt up and storms move the bottom, so treat this as an estimate and use official charts for navigation.

Clearance under a bridge

Published bridge clearances are usually measured from a high-water datum such as MHHW. With the datum set to MHHW, a value near 0 means the water is near a typical high tide, which is the tight case. A value below 0 means more room than the published clearance.